|
PARTS OPERATION
BEFORE YOU START your gas scooter make sure you are FAMILIAR WITH THESE INSTRUCTIONS, HAVE READ ALL WARNINGS, and that you are familiar with the location of the brake lever, the gas throttle and the engine kill switch.
STARTING THE ENGINE. Because your gas powered scooter has a clutch you need not worry about your rear wheel being off the ground when you start the engine, make sure that your foot is on the board. The
motorized scooter engine comes with a choke and bubble primer. Locate both on the engine. Follow the following instructions to start your engine:
Pump primer bulb until fuel flows steadily through clear overflow tube.
Move choke lever to closed position.
Pull starter until engine starts. Do not pull to end of rope.
Move choke to open position once engine is running.
Allow engine to warm up before using.
Once the engine is warmed up you can take off. Simply put both feet on the board and squeeze the gas throttle or you can push off with one foot at the same time as you squeeze the gas throttle. Drive slowly at first and become familiar with the throttle and the brake. Get a feel for how fast you can stop using both the brake and the
gas scooter engine compression.
|
